PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)
REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)
REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)
Detach the 2 clips and remove the deck trim side board LH.
REMOVE BATTERY SERVICE HOLE COVER LH
| *A | for Standard |
| *B | for Ottoman |
| *1 | Fastening Tape |
Detach the clip, fastening tape and remove the battery service hole cover LH.
DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE FRONT WHEEL LH
REMOVE FRONT FENDER MAIN SEAL LH
Loosen the clip labeled A in the illustration, and then remove the 3 clips and front fender main seal LH.
Tech Tips
Clip A cannot be removed.
REMOVE FRONT FENDER WHEEL OPENING MOULDING LH
Remove the 5 screws.
Detach the clip and remove the moulding.
REMOVE FRONT FENDER LINER LH
Remove the 15 screws, 6 clips and front fender liner LH.
DRAIN WASHER FLUID
Remove the washer hose from the windshield washer motor and pump, and drain the washer fluid.
REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
Disconnect the connector.
Remove the windshield washer motor and pump assembly as shown in the illustration.
REMOVE HEADLIGHT ASSEMBLY LH
REMOVE WASHER INLET SUB-ASSEMBLY
Remove the bolt and washer inlet.
REMOVE WINDSHIELD WASHER JAR ASSEMBLY
Disconnect the 3 connectors and detach the 4 clamps.
Remove the 3 bolts. Then detach guide A and remove the windshield washer jar and pump.
REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY
Remove the headlight cleaner motor and pump assembly together with the hose.
REMOVE HEADLIGHT CLEANER CONTROL RELAY
Detach the claw and remove the headlight cleaner control relay.
REMOVE LEVEL WARNING SWITCH ASSEMBLY
Remove the level warning switch assembly.