WASHER MOTOR REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    A01GWKI
  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    A01GZ3P
  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)


    1. A01GXQQ

      Detach the 2 clips and remove the deck trim side board LH.

  5. REMOVE BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02
      Text in Illustration
      *A for Standard
      *B for Ottoman
      *1 Fastening Tape

      Detach the clip, fastening tape and remove the battery service hole cover LH.

  6. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE FRONT WHEEL LH

  8. REMOVE FRONT FENDER MAIN SEAL LH


    1. A01H039E01

      Loosen the clip labeled A in the illustration, and then remove the 3 clips and front fender main seal LH.

      Tech Tips

      Clip A cannot be removed.

  9. REMOVE FRONT FENDER WHEEL OPENING MOULDING LH

    A01H219

    1. Remove the 5 screws.

    2. Detach the clip and remove the moulding.

  10. REMOVE FRONT FENDER LINER LH


    1. A01GZJH

      Remove the 15 screws, 6 clips and front fender liner LH.

  11. DRAIN WASHER FLUID


    1. A01GZDN

      Remove the washer hose from the windshield washer motor and pump, and drain the washer fluid.

  12. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


    1. A01H0FO

      Disconnect the connector.

    2. Remove the windshield washer motor and pump assembly as shown in the illustration.

  13. REMOVE HEADLIGHT ASSEMBLY LH

    Click here

  14. REMOVE WASHER INLET SUB-ASSEMBLY


    1. A01H0LZ

      Remove the bolt and washer inlet.

  15. REMOVE WINDSHIELD WASHER JAR ASSEMBLY


    1. Disconnect the 3 connectors and detach the 4 clamps.

      A01GZHNE01
    2. Remove the 3 bolts. Then detach guide A and remove the windshield washer jar and pump.

  16. REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY


    1. A01H06C

      Remove the headlight cleaner motor and pump assembly together with the hose.

  17. REMOVE HEADLIGHT CLEANER CONTROL RELAY


    1. A01GZXP

      Detach the claw and remove the headlight cleaner control relay.

  18. REMOVE LEVEL WARNING SWITCH ASSEMBLY


    1. A01GXCE

      Remove the level warning switch assembly.