AUTOMATIC LIGHT CONTROL SENSOR REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    A01GWKI

  2. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    A01GZ3P

  3. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)


    1. A01GXQQ

      Detach the 2 clips and remove the deck trim side board LH.

  4. REMOVE BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02
      Text in Illustration
      *A for Standard
      *B for Ottoman
      *1 Fastening Tape

      Detach the clip, fastening tape and remove the battery service hole cover LH.

  5. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  6. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  8. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

    A01GXSR

    1. Remove the screw.

    2. Detach the claw and remove the No. 1 side defroster nozzle duct.

  9. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

    A01H09F

    1. Remove the screw.

    2. Detach the claw and remove the No. 2 side defroster nozzle duct.

  10. REMOVE DEFROSTER NOZZLE ASSEMBLY

    A01GZ3T

    1. Remove the 3 screws and defroster nozzle assembly.

  11. REMOVE AUTOMATIC LIGHT CONTROL SENSOR

    A01H058

    1. Disconnect the connector.

    2. Detach the 2 claws to remove the automatic light control sensor.