HEADLIGHT DIMMER SWITCH REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    A01GWKI

  2. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    A01GZ3P

  3. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)


    1. A01GXQQ

      Detach the 2 clips and remove the deck trim side board LH.

  4. REMOVE BATTERY SERVICE HOLE COVER LH


    1. A01GZIME02
      Text in Illustration
      *A for Standard
      *B for Ottoman
      *1 Fastening Tape

      Detach the clip, fastening tape and remove the battery service hole cover LH.

  5. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  6. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    Click here

  8. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

    A01H1QO

    1. Disconnect the connectors.

    2. Using a screwdriver, detach the claw to remove the windshield wiper switch assembly.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      If the claw is pressed forcefully, it will break.

  9. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY

    A01GW7V

    1. While loosening the band clamp, detach the claw to remove the turn signal switch assembly.

      Note

      If the claw is pressed forcefully, it will break.