INSIDE HANDLE LIGHT REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A01GWOPE03
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 3 claws and remove the front door inside handle bezel plug LH.

      Tech Tips

      Tape the screwdriver tip before use.

  2. REMOVE FRONT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY LH


    1. A01GWMP

      Using a moulding remover D, detach the 2 clips.

    2. Disconnect the connector and remove the power window regulator master switch assembly with front door armrest base panel.

      Tech Tips

      Tape the screwdriver tip before use.

  3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01GYVZ

      Remove the 3 screws.

    2. Detach the 13 clips and remove the front door trim board sub-assembly LH.

    3. Disconnect the connector.

    4. A01GWSZ

      Disconnect the 2 cables from the inside handle.

  4. REMOVE FRONT DOOR INSIDE HANDLE ILLUMINATION LIGHT ASSEMBLY LH

    A01GW8B

    1. Detach the claw.

    2. Disconnect the connector to remove the front door inside handle illumination light assembly.

  5. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A01GYVW

      Using a screwdriver, detach the 3 claws and remove the rear door inside handle bezel plug LH.

      Tech Tips

      Tape the screwdriver tip before use.

  6. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

    A01GZMDE01

    1. Apply protective tape to the area around the rear power window regulator switch assembly with rear door armrest base panel.

    2. Using a clip remover, detach the 2 clips in the order shown in the illustration.

      Text in Illustration
      *1 Protective Tape
    3. A01GXAJ

      Disconnect the connector.

    4. Remove the screw and illumination light.

    5. Remove the rear power window regulator switch assembly with rear door armrest base panel.

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. w/o Rear Door Sunshade:

      Click here

    2. w/ Rear Door Sunshade:

      Click here

  8. REMOVE REAR DOOR INSIDE HANDLE ILLUMINATION LIGHT ASSEMBLY LH

    A01H1UDE04

    1. Detach the claw.

    2. Disconnect the connector to remove the rear door inside handle illumination light assembly.