LIGHTING SYSTEM Rear Vanity Light does not Illuminate

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   CHECK HARNESS AND CONNECTOR (MAP LIGHT - BATTERY)

   
   

   1. Disconnect the X4 light connectors.

   2. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition X4-27 (DOME) - Body ground Always 11 to 14 V

   
   
   • OKClick here
   • NGClick here
2. Click here

   CHECK HARNESS AND CONNECTOR (MAP LIGHT - REAR VANITY LIGHT)

   
   

   1. Disconnect the X4, X6, X11 (for LH) and X14 (for RH) light connectors.

   2. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      for LH
      Tester Connection Condition Specified Condition X4-26 (+B2) - X11-1 (B) Always Below 1 Ω X4-12 (RLVS) - X11-3 (E) Always Below 1 Ω X6-16 (RLVT) - X11-2 (RLVT) Always Below 1 Ω X4-26 (+B2) - Body ground Always 10 kΩ or higher X4-12 (RLVS) - Body ground Always 10 kΩ or higher X6-16 (RLVT) - Body ground Always 10 kΩ or higher
      for RH
      Tester Connection Condition Specified Condition X4-10 (+B1) - X14-1 (B) Always Below 1 Ω X4-13 (RRVS) - X14-3 (E) Always Below 1 Ω X6-14 (RRVT) - X14-2 (RRVT) Always Below 1 Ω X4-10 (+B) - Body ground Always 10 kΩ or higher X4-13 (RRVS) - Body ground Always 10 kΩ or higher X6-14 (RRVT) - Body ground Always 10 kΩ or higher

   
   
   • OKClick here
   • NGClick here
3. Click here

   CHECK REAR VANITY LIGHT ASSEMBLY (OPERATION)

   
   

   1. Check that the malfunction disappears when the rear vanity light is replaced with a normal one (see pageClick here).

      OK
      Malfunction disappears

   
   
   • OKClick here
   • NGClick here
4. Click here

   REPAIR OR REPLACE HARNESS OR CONNECTOR

5. Click here

   REPAIR OR REPLACE HARNESS OR CONNECTOR

6. Click here

   END (REPLACE REAR VANITY LIGHT ASSEMBLY)Click here

7. Click here

   REPLACE MAP LIGHT ASSEMBLYClick here