LIGHTING SYSTEM, Diagnostic DTC:B2471

DESCRIPTION

This DTC is output when the vehicle is tilted because of excessive load, towing or modification.

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   CLEAR DTC

   
   

   1. Clear the DTC (Click here).

   
   
   • NEXTClick here
2. Click here

   CHECK FOR DTC

   
   

   1. Turn the power switch on (IG).

   2. Check for DTC (Click here).

      OK
      DTC B2471 output does not occur

   
   
   • OKClick here
   • NGClick here
3. Click here

   CHECK FOR DTC

   
   

   1. Place the vehicle on a level surface and perform a driving test on a straight road where the traffic lanes are visible.

   2. Check for DTC (Click here).

      OK
      DTC B2471 output does not occur

      Note:
      

      • Correct the cause of the tilt (excessive load, towing, modification) during the diagnosis.

      • Depending on driving conditions, it may take some time until the DTC is cleared, or the DTC may not be cleared.

   
   
   • OKClick here
   • NGClick here
4. Click here

   ADJUST INNER REAR VIEW MIRROR ASSEMBLY (ADAPTIVE HIGH BEAM SYSTEM SENSOR)

   
   

   1. Perform beam axis initialization for the inner rear view mirror assembly (Click here).

   2. Turn the power switch on (IG).

   3. Check for DTC (Click here).

      OK
      DTC B2471 output does not occur

   
   
   • OKClick here
   • NGClick here
5. Click here

   CHECK INNER REAR VIEW MIRROR ASSEMBLY (ADAPTIVE HIGH BEAM SYSTEM SENSOR)

   
   

   1. Temporarily replace the inner rear view mirror (adaptive high beam system sensor) with a new or normally functioning one (Click here).

   2. Perform beam axis initialization for the inner rear view mirror assembly (adaptive high beam system sensor) (Click here).

   3. Turn the power switch on (IG).

   4. Check for DTC (Click here).

      OK
      DTC B2471 output does not occur

   
   
   • OKClick here
   • NGClick here
6. Click here

   USE SIMULATION METHOD TO CHECKClick here

7. Click here

   END (VEHICLE IS TILTED)

8. Click here

   REPLACE AFS ECUClick here

9. Click here

   END (INNER REAR VIEW MIRROR ASSEMBLY [ADAPTIVE HIGH BEAM SYSTEM SENSOR] WAS DEFECTIVE)

10. Click here

    END (INNER REAR VIEW MIRROR [ADAPTIVE HIGH BEAM SYSTEM SENSOR] BEAM AXIS INCOMPLETE)