KNOCK SENSOR INSTALLATION

Tech Tips

When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.


  1. INSTALL KNOCK SENSOR

    A01GY4WE01

    1. Install the 4 knock sensors with the 4 bolts so that the sensors are angled as shown in the illustration.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Tech Tips

      The acceptable installation angle of the knock sensors is between 10° upwards and downwards from the horizontal position.

    2. Connect the 4 knock sensor connectors.

  2. INSTALL SEPARATOR CASE

    A01GWID

    1. Install the separator case with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
    2. A01H1VE

      Connect the fuel pressure sensor connector.

  3. INSTALL NO. 4 FUEL PIPE SUB-ASSEMBLY

    A01GZ1JE01
    Text in Illustration
    *1 Union Nut Wrench
    *2 Separator Case
    *3 Fuel Pipe Protector

    1. Temporarily install the No. 4 fuel pipe sub-assembly.

    2. Using a 19 mm union nut wrench, tighten the No. 4 fuel pipe sub-assembly in the order shown in the illustration.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note


      • After installing the No. 4 fuel pipe sub-assembly, check that the fuel pipe protector contacts with the separator case.

      • Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

      Tech Tips

      Make sure use the union nut wrench and torque wrench are connected in a straight line.

  4. INSTALL NO. 2 ENGINE COVER SUB-ASSEMBLY LH

  5. INSTALL NO. 2 ENGINE COVER SUB-ASSEMBLY

  6. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

  7. INSTALL INTAKE MANIFOLD

    Click here