Click here

KNOCK SENSOR REMOVAL

Click here
Click here Click here
Tip:

When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.

Click here
  1. Click here

    REMOVE INTAKE MANIFOLD

    (Click here)

  2. Click here

    REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

  3. Click here

    REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY

  4. Click here

    REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY LH

  5. Click here

    REMOVE NO. 4 FUEL PIPE SUB-ASSEMBLY


    1. A01GW61E06

      Using a 19 mm union nut wrench, remove the No. 4 fuel pipe sub-assembly.

      Table 1. Text in Illustration
      *1 Union Nut Wrench
  6. Click here

    REMOVE SEPARATOR CASE


    1. A01H1VE

      Disconnect the fuel pressure sensor connector.

    2. A01GWID

      Remove the 4 bolts and separator case.

  7. Click here

    REMOVE KNOCK SENSOR


    1. Disconnect the 4 knock sensor connectors.

    2. Remove the 4 bolts and 4 knock sensors.