REMOVE V-BANK COVER SUB-ASSEMBLY
While using both hands, lift the rear side of the V-bank cover sub-assembly upwards to detach the 4 clips labeled B. Slide the V-bank cover sub-assembly towards the front of the vehicle to detach the 2 clips labeled A, and remove the V-bank cover sub-assembly.
Note
The V-bank cover sub-assembly may be damaged if its front and rear are lifted at the same time.
REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY
Remove the 5 clips labeled A.
Lift up the air cleaner inlet cover sub-assembly to detach the 4 clips labeled B, and remove the air cleaner inlet cover sub-assembly.
REMOVE NO. 1 AIR CLEANER INLET
Remove the 2 bolts.
Hold the No. 1 air cleaner inlet by the protrusions labeled A and B, and detach the connections.
Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled C.
Hold the No. 1 air cleaner inlet by the protrusions labeled D and E, and detach the connections.
Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled F.
REMOVE INTAKE AIR CONNECTOR PIPE
Disconnect the No. 1 ventilation hose and No. 2 ventilation hose from the intake air connector pipe.
Using a clip remover, detach the 2 wire harness clamps.
Loosen the 3 hose clamps, and remove the intake air connector pipe.
REMOVE V-RIBBED BELT
Rotate the tensioner pulley counterclockwise to loosen the V-ribbed belt tension assembly.
Tech Tips
The pulley bolt for the V-ribbed belt tensioner assembly has a left-handed thread.
While turning the V-ribbed belt tensioner assembly counterclockwise, align the holes. Insert a bar with a diameter of 5 mm (0.197 in.) into the holes to fix the V-ribbed belt tensioner assembly in place.
Remove the V-ribbed belt.