VVT SENSOR INSTALLATION

Tech Tips

When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.


  1. INSTALL VVT SENSOR


    1. A01H1LKE01

      Install the 4 VVT sensors with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    2. Connect the 4 VVT sensor connectors.

  2. INSTALL AIR CLEANER ASSEMBLY RH


    1. A01GYYNE01

      Align the air cleaner cases 2 holes to the 2 stud bolts and attach the air cleaner case RH to the boss. Then install the 2 nuts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    2. Install the air cleaner filter element to the air cleaner case RH.

    3. A01GZS4

      Install the air cleaner cap RH and secure the 2 clamps.

    4. Connect the mass air flow meter connector.

  3. INSTALL AIR CLEANER ASSEMBLY LH


    1. A01GY5BE01

      Align the air cleaner cases 2 holes to the 2 stud bolts and attach the air cleaner case LH to the boss. Then install the 2 nuts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    2. Install the air cleaner filter element to the air cleaner case LH.

    3. A01H1MY

      Install the air cleaner cap LH and secure the 2 clamps.

    4. Connect the mass air flow meter connector.

  4. INSTALL NO. 1 AIR CLEANER INLET


    1. A01GYPCE01

      Align the holes with the connection areas labeled A, and attach the No. 1 air cleaner inlet.

    2. Install the No. 1 air cleaner inlet with the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  5. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY


    1. A01GWDEE01

      Attach the 4 clips labeled B.

      Note


      • Make sure the clips are attached securely.

      • Attaching the clips forcefully or hitting the top of the clips may damage them.

    2. Install the air cleaner inlet cover sub-assembly with the 5 clips labeled A.

  6. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01GZ6XE01

      After sliding the V-bank cover sub-assembly from the vehicle front to the rear to attach the 2 clips labeled A, attach the 4 clips labeled B and install the V-bank cover sub-assembly.

      CAUTION:


      • Make sure the clips are attached securely.

      • Attaching the clips forcefully or hitting the top of the clips may damage them.