THROTTLE BODY REMOVAL


  1. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01GZ6XE01

      While using both hands, lift the rear side of the V-bank cover sub-assembly upwards to detach the 4 clips labeled B. Slide the V-bank cover sub-assembly towards the front of the vehicle to detach the 2 clips labeled A, and remove the V-bank cover sub-assembly.

      Note

      The V-bank cover sub-assembly may be damaged if its front and rear are lifted at the same time.

  2. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY


    1. A01GWDEE01

      Remove the 5 clips labeled A.

    2. Lift up the air cleaner inlet cover sub-assembly to detach the 4 clips labeled B, and remove the air cleaner inlet cover sub-assembly.

  3. REMOVE NO. 1 AIR CLEANER INLET


    1. A01GY2C

      Remove the 2 bolts.

    2. A01H12BE01

      Hold the No. 1 air cleaner inlet by the protrusions labeled A and B, and detach the connections.

    3. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled C.

    4. Hold the No. 1 air cleaner inlet by the protrusions labeled D and E, and detach the connections.

    5. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled F.

  4. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH


    1. A01H0ML

      Remove the 5 screws and front wheel opening extension pad LH.

  5. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. REMOVE NO. 1 ENGINE UNDER COVER


    1. A01GYE9

      Remove the 13 screws, 7 clips and No. 1 engine under cover.

  7. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator reservoir cap and vent plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug.

      A01H1N0E01
      Text in Illustration
      *1 Radiator Reservoir *2 Radiator Reservoir Cap
      *3 Cylinder Block Drain Cock Plug *4 Vent Plug
      *5 No. 1 Radiator Hose *6 Radiator Drain Cock Plug

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. A01GX4HE02
      Text in Illustration
      *1 Vent Plug

      Remove the radiator reservoir cap, and using a 6 mm hexagon wrench, remove the vent plug.

    3. Drain the coolant.

    4. Loosen the 2 cylinder block drain cock plugs.

  8. REMOVE INTAKE AIR CONNECTOR PIPE

    A01GYHY

    1. Disconnect the No. 1 ventilation hose and No. 2 ventilation hose from the intake air connector pipe.

    2. Using a clip remover, detach the 2 wire harness clamps.

    3. Loosen the 3 hose clamps, and remove the intake air connector pipe.

  9. REMOVE THROTTLE BODY ASSEMBLY

    A01GXRA

    1. Disconnect the throttle body motor connector.

    2. Remove the 4 bolts and throttle body assembly.

    3. A01GYDRE01

      Disconnect the No. 4 and No. 5 water by-pass hoses from the throttle body assembly.

    4. Remove the gasket from the intake manifold.