BACK DOOR OUTSIDE GARNISH (w/o Tire Carrier) REMOVAL


  1. REMOVE BACK DOOR CENTER GARNISH


    1. A01DQF8

      Detach the 4 clips and remove the back door center garnish.

  2. REMOVE BACK DOOR SIDE GARNISH LH


    1. A01DN12

      Detach the 2 clips and claw and remove the back door side garnish.

  3. REMOVE BACK DOOR SIDE GARNISH RH


    1. A01DNDA

      Detach the 2 clips and claw and remove the back door side garnish.

  4. REMOVE BACK DOOR TRIM COVER


    1. A01DRRP

      Remove the back door trim cover as shown in the illustration.

  5. REMOVE UPPER TOOL BOX PANEL SUB-ASSEMBLY


    1. A01DOTG

      Remove the upper tool box panel sub-assembly as shown in the illustration.

  6. REMOVE TOOL CASE


    1. A01DN08

      Detach the 2 claws and remove the tool case.

  7. REMOVE BACK DOOR LOCK COVER


    1. A01DQKZ

      Using moulding remover B, detach the clip and 6 claws and remove the back door lock cover.

  8. REMOVE BACK DOOR TRIM PANEL ASSEMBLY


    1. A01DLZT

      Detach the claw and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01DREP

      Remove the screw.

    3. w/o Back Door Tire Carrier:


      1. A01DUAH

        Remove the bolt.

      2. Detach the 15 clips and remove the back door trim panel assembly.

    4. w/ Back Door Tire Carrier:


      1. A01DQEH

        Remove the bolt.

      2. Detach the 16 clips and remove the back door trim panel assembly.

    5. for Face to Face Seat Type:


      1. A01DN76

        Remove the screw and bolt.

      2. Detach the 15 clips and remove the back door trim panel assembly.

  9. REMOVE BACK DOOR SERVICE HOLE COVER


    1. A01DN2I

      Remove the service hole cover.

  10. REMOVE BACK DOOR OUTSIDE HANDLE LH


    1. w/ Back Door Tire Carrier:


      1. A01DSPEE01
        Text in Illustration
        *1 Hole Plug

        Remove the hole plug.

      2. Remove the 2 nuts and back door outside handle.

      3. Disconnect the cable.

    2. w/o Back Door Tire Carrier:


      1. A01DUD3

        Remove the 2 nuts and back door outside handle.

      2. Disconnect the cable.

  11. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

    A01DT56

    1. Remove the nut.

    2. Disconnect the connector.

    3. Detach the clamp and disconnect the back door electrical key switch wire harness from the back door panel.

    4. A01DUKDE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the back door outside garnish sub-assembly.

    5. Using moulding remover B, detach the 19 clips and remove the back door garnish sub-assembly.

  12. REMOVE NO. 2 BACK DOOR OUTSIDE GARNISH


    1. A01DN43

      Detach the 3 claws and 2 guides and remove the No. 2 back door outside garnish.