BACK DOOR OUTSIDE GARNISH (w/ Tire Carrier) INSTALLATION


  1. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    1. Attach the 4 clips to install the back door outside garnish.

    2. Install the 4 nuts.

    3. Connect the connector.

  2. INSTALL BACK DOOR OUTSIDE HANDLE LH


    1. w/ Back Door Tire Carrier:


      1. A01DQYME01
        Text in Illustration
        *1 Hole Plug

        Connect the cable.

      2. Install the back door outside handle with the 2 nuts.

        Torque:
        5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

      3. Install the hole plug.

    2. w/o Back Door Tire Carrier:


      1. A01DN3D

        Connect the cable.

      2. Install the back door outside handle with the 2 nuts.

        Torque:
        5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  3. INSTALL BACK DOOR SERVICE HOLE COVER


    1. A01DOLME01
      Text in Illustration
      *1 Reference Point

      Apply new butyl tape to the back door panel.

    2. Attach the rear door service hole cover using to the reference points on the rear door panel.

      Note


      • There should be no wrinkles or folds after attaching the service hole cover.

      • After attaching the service hole cover, check the seal quality.

  4. INSTALL BACK DOOR INSIDE HANDLE SUB-ASSEMBLY (for Face to Face Seat Type)


    1. A01DU9K

      Connect the 2 cables to the inside handle sub-assembly.

    2. Attach the claws and guide to install the inside handle sub-assembly.

  5. INSTALL BACK DOOR TRIM PANEL ASSEMBLY


    1. w/o Back Door Tire Carrier:


      1. Attach the 15 clips to install the back door trim panel assembly.

      2. Install the bolt.

    2. w/ Back Door Tire Carrier:


      1. Attach the 16 clips to install the back door trim panel assembly.

      2. Install the bolt.

    3. for Face to Face Seat Type:


      1. Attach the 15 clips to install the back door trim panel assembly.

      2. Install the bolt.

    4. Install the screw.

    5. Attach the claw to install the cover.

  6. INSTALL BACK DOOR INSIDE HANDLE BEZEL (for Face to Face Seat Type)


    1. Attach the 5 claws to install the back door inside handle bezel.

    2. Install the screw.

  7. INSTALL TOOL CASE


    1. Attach the 2 claws to install the tool case.

  8. INSTALL UPPER TOOL BOX PANEL SUB-ASSEMBLY


    1. A01DNF3

      Attach the 3 claws.

    2. Install the upper tool box panel sub-assembly as shown in the illustration.

  9. INSTALL BACK DOOR TRIM COVER


    1. A01DNQ8

      Attach the 4 claws.

    2. Install the back door trim cover as shown in the illustration.

  10. INSTALL BACK DOOR SIDE GARNISH LH


    1. Attach the 2 clips and claw to install the back door side garnish.

  11. INSTALL BACK DOOR SIDE GARNISH RH


    1. Attach the 2 clips and claw to install the back door side garnish.

  12. INSTALL CENTER BACK DOOR GARNISH


    1. Attach the 4 clips to install the back door center garnish.