HEIGHT CONTROL SENSOR INSPECTION


  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

    A01DQUTE10
    Text in Illustration
    *a

    Component without harness connected

    (Rear Height Control Sensor)

    		 *b Min. Low
    *c Normal *d Max. High
    A01DQPB 45° A01DMKT 45°

    1. Connect 3 dry batteries of 1.5 V in series.

    2. Connect the positive (+) end of the batteries to terminal 1 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 3 (SHG).

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      2 (SHRR) - 3 (SHG) Max. high (45°) 4.4 to 4.6 V
      Normal (0°) 2.3 to 2.6 V
      Min. low (-45°) 0.4 to 0.6 V

      Note

      Do not apply a voltage of 5 V or higher.

      If the result is not as specified, replace the rear height control sensor sub-assembly.