SIDE TURN SIGNAL LIGHT ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE OUTER REAR VIEW MIRROR LH


    1. Remove the outer rear view mirror LH Click here.

  2. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

    A01DOG7E01
    Text in Illustration
    *1 Protective Tape

    1. Push the upper part of the mirror surface and tilt it.

    2. Using a moulding remover, detach the 4 claws and separate the outer rear view mirror glass from the mirror body.

      Tech Tips

      Apply protective tape to the outer rear view mirror to prevent it from being damaged.

    3. Disconnect the connectors and remove the mirror glass.

  3. REMOVE LOWER OUTER MIRROR COVER LH

    A01DREQE02

    Tech Tips

    Be sure to detach the claws of the outer mirror cover in the order shown in the illustration.


    1. A01DN3EE01
      Text in Illustration
      *1 Protective Tape

      Using 2 screwdrivers, detach the 2 claws.

      Tech Tips

      Tape the screwdriver tip before use.

    2. Insert a screwdriver into the slot as shown in the illustration and push on the outer mirror body to create a space between the outer mirror body and outer mirror cover.

      Note

      Be careful not to break the ribs.

      Tech Tips

      Tape the screwdriver tip before use.

      A01DPMIE01
      Text in Illustration
      *1 Protective Tape *2 Rib
      *a Inner Side of Outer Mirror Cover - -
    3. A01DTFLE01
      Text in Illustration
      *1 Protective Tape

      Insert a moulding remover into the space made between the outer mirror body and outer mirror cover.

      Note

      Do not insert the moulding remover more than 4 mm (0.157 in.).

      Tech Tips

      Tape the moulding remover before use.

    4. A01DT4YE01

      Slide the moulding remover downwards as shown in the illustration to detach the 2 claws.

      Note


      • Do not insert the moulding remover more than 4 mm (0.157 in.).

      • Do not slide the moulding remover past the point approximately 40 mm (1.57 in.) from the bottom edge of the outer mirror cover as the outer mirror body will become damaged.

      Standard
      Area Specified Condition
      a 40.0 mm (1.57 in.)

    5. Remove the moulding remover.

    6. A01DNKME01
      Text in Illustration
      *1 Protective Tape

      Insert a moulding remover between the outer mirror cover and outer mirror body as shown in the illustration and detach the claw.

    7. A01DN6SE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the claw.

    8. A01DUF1

      Detach the 2 claws and remove the outer mirror cover.

      Note

      When removing the cover, be careful not to damage the side turn signal light assembly or cover.

  4. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH


    1. A01DQT6

      Remove the 3 screws and light.

    2. Disconnect the connector.