WASHER LEVEL WARNING SWITCH INSPECTION


  1. INSPECT LEVEL WARNING SWITCH ASSEMBLY

    Tech Tips

    The following check should be performed with the windshield washer motor and pump assembly installed to the windshield washer jar assembly.


    1. Fill the windshield washer jar assembly with washer fluid.

    2. A01DTRGE02
      Text in Illustration
      *a

      Component without harness connected

      (Level Warning Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (S) - 2 (E) Fluid volume is more than 750 cc (45.7 cu.in.) 10 kΩ or higher
      1 (S) - 2 (E) Fluid volume is less than 550 cc (33.5 cu.in.) Below 1 Ω

      Tech Tips

      When the fluid volume is between 550 and 750 cc (33.5 and 45.7 cu.in.), the level warning switch assembly may be on or off.

      If the result is not as specified, replace the level warning switch assembly.