FRONT WIPER MOTOR ON-VEHICLE INSPECTION


  1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)


    1. A01DSKRE01

      Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and the wipers do not come into contact with the vehicle body.

      Standard
      Area Standard Condition
      A 47.5 mm (1.87 in.)
      B 30.4 mm (1.20 in.)
      C 9.5 mm (0.374 in.)
      Text in Illustration
      *1 Moulding Edge
    2. A01DRZNE01
      Text in Illustration
      *A for RH Side
      *B for LH Side
      *1 Cowl Side Seal Edge
      *2 Louver Edge

      Stop the front wiper motor and link assembly operation.

    3. Check the automatic stop position.

      OK
      The front wipers stop at the positions shown in the illustration.
      Standard
      Area Standard Condition
      a 35.6 to 55.6 mm (1.40 to 2.19 in.)
      b 18.9 to 38.9 mm (0.744 to 1.53 in.)

      If the result is not as specified, remove and reinstall the wiper arm and blade assembly, and then perform the on-vehicle inspection described above to inspect the wiper motor and link assembly again. If the result is not as specified again, inspect the wiper motor and link assembly with it removed from the vehicle body Click here.

  2. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)


    1. A01DU1BE01

      Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and the wipers do not come into contact with the vehicle body.

      Standard
      Area Standard Condition
      A 47.5 mm (1.87 in.)
      B 30.4 mm (1.20 in.)
      C 13.0 mm (0.512 in.)
      Text in Illustration
      *1 Moulding Edge
    2. A01DSHFE01
      Text in Illustration
      *A for LH Side
      *B for RH Side
      *1 Cowl Side Seal Edge
      *2 Louver Edge

      Stop the front wiper motor and link assembly operation.

    3. Check the automatic stop position.

      OK
      The front wipers stop at the positions shown in the illustration.
      Standard
      Area Standard Condition
      a 35.6 to 55.6 mm (1.40 to 2.19 in.)
      b 18.9 to 38.9 mm (0.744 to 1.53 in.)

      If the result is not as specified, remove and reinstall the wiper arm and blade assembly, and then perform the on-vehicle inspection described above to inspect the wiper motor and link assembly again. If the result is not as specified again, inspect the wiper motor and link assembly with it removed from the vehicle body Click here.