SLIDING ROOF SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

VEHICLE BROUGHT TO WORKSHOP

NEXT

INSPECT BATTERY VOLTAGE

If the voltage is below 11 V, recharge or replace the battery before proceeding.

NEXT

CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

1. Use the intelligent tester to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output (for LHD with Entry and Start System)	B
   CAN DTC is output (for LHD without Entry and Start System)	C
   CAN DTC is output (for RHD with Entry and Start System)	D
   CAN DTC is output (for RHD without Entry and Start System)	E

   
   

   B

   Go to CAN COMMUNICATION SYSTEM Click here

   C

   Go to CAN COMMUNICATION SYSTEM Click here

   D

   Go to CAN COMMUNICATION SYSTEM Click here

   E

   Go to CAN COMMUNICATION SYSTEM Click here

   A

CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*

1. Use the intelligent tester to check if the LIN communication system is functioning normally.

   Result

   Result	Proceed to
   LIN DTC is not output	A
   LIN DTC is output	B

   
   

   B

   Go to LIN COMMUNICATION SYSTEM Click here

   A

CHECK FOR DTC*

1. Check for DTCs and note any codes that are output Click here.

2. Clear the DTCs.

3. Recheck for DTCs.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   
   

   B

   Go to DIAGNOSTIC TROUBLE CODE CHART Click here

   A

PROBLEM SYMPTOMS TABLE

1. Refer to the Problem Symptoms Table Click here.

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   
   

   B

   Go to step 8

   A

OVERALL ANALYSIS AND TROUBLESHOOTING*

1. Operation Check Click here

2. Data List/Active Test Click here

3. Terminals of ECU Click here

   
   

   NEXT

ADJUST, REPAIR OR REPLACE

NEXT

INITIALIZATION

1. Initialization Click here

   
   

   NEXT

CONFIRMATION TEST

NEXT