SLIDING ROOF SYSTEM Sliding Roof ECU Power Source Circuit

DESCRIPTION

If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof drive gear sub-assembly power source circuit.

WIRING DIAGRAM

A01DNK0E01

INSPECTION PROCEDURE

Note


  • When the sliding roof drive gear sub-assembly is removed and reinstalled or replaced, the sliding roof drive gear sub-assembly must be initialized Click here.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - BATTERY AND BODY GROUND)

    A01DOIEE01
    Text in Illustration
    *a

    Front view of wire harness connector

    (to Sliding Roof Drive Gear Sub-assembly)

    1. Disconnect the W2 ECU connector.

    2. Measure the resistance and voltage according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      W2-2 (E) - Body ground Always Below 1 Ω
      Standard Voltage
      Tester Connection Condition Specified Condition
      W2-1 (B) - Body ground Always 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY Click here