REAR POWER WINDOW SWITCH REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH


    1. A01DNXC

      Using moulding remover A, detach the 3 claws and remove the rear door inside handle bezel as shown in the illustration.

  2. REMOVE ASSIST GRIP COVER LH


    1. A01DNUH

      Using moulding remover A, detach the 8 claws and remove the assist grip cover.

  3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01DMRN

      Remove the 3 screws.

    2. Using a clip remover, detach the 9 clips.

    3. A01DQQP

      Pull out the rear door trim board sub-assembly in the direction indicated by the arrow in the illustration.

    4. Raise the rear door trim board sub-assembly to detach the 4 claws and remove the rear door trim board sub-assembly together with the rear door inner glass weatherstrip.

    5. A01DORR

      Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly as shown in the illustration.

    6. A01DNA1E02
      Text in Illustration
      *A for 14 Speakers
      *B for 9 Speakers

      Disconnect each connector.

    7. A01DR21

      Using a screwdriver, detach the claw and remove the clamp.

  4. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH


    1. A01DPM5

      Using a screwdriver, detach the 3 claws and remove the rear door inner glass weatherstrip from the rear door trim board sub-assembly as shown in the illustration.

  5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    1. A01DM3B

      Detach the 2 claws and remove the rear power window regulator switch assembly.