POWER WINDOW CONTROL SYSTEM Key-off Operation Function Operates even if Operating Conditions are not Satisfied

Click here

DESCRIPTION

• When the front doors are closed, each power window regulator motor can control its power window operation for approximately 43 seconds after the ignition switch is turned from ON to off by receiving operation permission signals from the main body ECU (instrument panel junction block). However, when approximately 43 seconds have elapsed, or a front side door is opened within approximately 43 seconds of the ignition switch being turned off, all the power window regulator motors disable manual operation.

• During the auto function operation, when 43 seconds have elapsed and key-off operation is prohibited, the window operation stops immediately.

• The front passenger side power window and the rear power windows cannot be operated when the window lock switch is on.

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE

1. Click here

   CHECK LIN COMMUNICATION SYSTEM

   
   

   1. Check for LIN communication system DTCs related to the power window control system (Click here).

      OK
      LIN communication system DTCs are not output.

   
   
   • OKClick here
   • NGClick here
2. Click here

   CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH OFF

   
   

   1. Check the power window operation function after the ignition switch is turned off (Click here).

      Table 1. Result

      Result	Proceed to
      Front side door is opened within 43 sec. but power windows can still operate	A
      43 sec. pass and power windows can still operate	B

   
   
   • AClick here
   • BClick here
3. Click here

   READ VALUE USING INTELLIGENT TESTER (FRONT DOOR COURTESY LIGHT SWITCH)

   
   

   1. Use the Data List to check if the main body ECU (multiplex network body ECU) is functioning properly (Click here).

      Table 2. Main Body

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      FL Door Courtesy SW	Front door courtesy light switch LH signal / ON or OFF	ON: Front door LH closed OFF: Front door LH open	-
      FR Door Courtesy SW	Front door courtesy light switch RH signal / ON or OFF	ON: Front door RH closed OFF: Front door RH open	-

      OK
      On tester screen, each item changes between ON and OFF according to above chart.

   
   
   • OKClick here
   • NGClick here
4. Click here

   CHECK FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY

   
   

   1. Open a front door and check that the map light illuminates (Click here).

      OK
      Map light illuminates.

   
   
   • OKClick here
   • NGClick here
5. Click here

   CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY

   
   

   1. Temporarily replace the driver side junction block with a new or normally functioning one.

   2. Check the front door open and close function.

   
   
   • OKClick here
   • NGClick here
6. Click here

   GO TO LIN COMMUNICATION SYSTEMClick here

7. Click here

   REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLYClick here

8. Click here

   REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)Click here

9. Click here

   END (DRIVER SIDE JUNCTION BLOCK ASSEMBLY IS DEFECTIVE)