RELAY (for Magnet Clutch Control) ON-VEHICLE INSPECTION


  1. REMOVE MAGNET CLUTCH RELAY

    A01DPC4E01
    Text in Illustration
    *1 Magnet Clutch Relay

    1. Remove the magnet clutch relay from the engine room relay block.

  2. INSPECT MAGNET CLUTCH RELAY

    A01DMN9E97

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      • If the result is not as specified, replace the magnet clutch relay.

  3. INSTALL MAGNET CLUTCH RELAY


    1. Install the magnet clutch relay to the engine room relay block.