HEATER SWITCH REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH

    A01DNTTE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the door scuff plate.

    2. Using a screwdriver, detach the 4 clips, 10 claws and 2 guides and remove the door scuff plate.

      Tech Tips

      Tape the screwdriver tip before use.

  2. REMOVE COWL SIDE TRIM BOARD LH

    A01DQEI

    1. Remove the clip.

    2. Detach the clip and claw and remove the cowl side trim board.

  3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01DSZY

    1. for LHD:


      1. Remove the screw.

      2. Detach the 2 clips and 2 guides and remove the No. 1 instrument panel under cover.

      3. Disconnect each connector.

    2. A01DORU

      for RHD:


      1. Remove the screw.

      2. Detach the 3 clips and 2 guides and remove the No. 1 instrument panel under cover.

      3. Disconnect each connector.

  4. REMOVE INSTRUMENT SIDE PANEL LH

    A01DNBCE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel.

    2. Using a moulding remover, detach the 5 clips, claw and 3 guides and remove the instrument side panel.

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

    A01DM0OE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument cluster finish panel ornament.

    2. Using a moulding remover, detach the 3 clips and remove the instrument cluster finish panel ornament.

  6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for LHD)

    A01DP35

    1. Detach the 4 clips.

    2. Disconnect each connector and remove the instrument panel finish panel.

  7. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

    A01DREC

    1. Detach the 4 clips.

    2. Disconnect each connector and remove the instrument panel finish plate garnish.

  8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

    A01DP35

    1. Detach the 4 clips.

    2. Disconnect each connector and remove the instrument panel finish panel.

  9. REMOVE HEATER SWITCH ASSEMBLY (for LHD)


    1. A01DMNX

      Detach the 2 claws and remove the switch.

  10. REMOVE HEATER SWITCH ASSEMBLY (for RHD)


    1. A01DUO6

      Detach the 2 claws and remove the switch.

  11. REMOVE IDLE UP SWITCH (for LHD)


    1. A01DMNX

      Detach the 2 claws and remove the switch.

  12. REMOVE IDLE UP SWITCH (for RHD)


    1. A01DUO6

      Detach the 2 claws and remove the switch.