ROOM TEMPERATURE SENSOR (for Front Side) REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

    A01DM0OE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument cluster finish panel ornament.

    2. Using a moulding remover, detach the 3 clips and remove the instrument cluster finish panel ornament.

  3. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

    A01DREC

    1. Detach the 4 clips.

    2. Disconnect each connector and remove the instrument panel finish plate garnish.

  4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    A01DP35

    1. Detach the 4 clips.

    2. Disconnect each connector and remove the instrument panel finish panel.

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    A01DN01

    1. Detach the 4 claws, 2 clips and 2 guides and remove the instrument cluster finish panel.

  6. REMOVE COMBINATION METER ASSEMBLY


    1. A01DU19

      Remove the 4 screws and combination meter assembly.

    2. Disconnect the 2 connectors.

  7. REMOVE COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)

    A01DTSS

    1. Disconnect the connector and hose.

    2. Detach the 2 claws and remove the cooler thermistor.