AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) Air Conditioning Control Panel Circuit

DESCRIPTION

This circuit consists of the integration control and panel assembly and air conditioning amplifier assembly. When the integration control and panel assembly is operated, signals are transmitted to the air conditioning amplifier assembly through the LIN communication system.

If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate when the integration control and panel assembly is operated.

WIRING DIAGRAM

A01DRR2E02

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - AIR CONDITIONING AMPLIFIER)


    1. Disconnect the G25 amplifier connector.

    2. Disconnect the G23 panel connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G23-3 (LIN1) - G25-37 (LIN1) Always Below 1 Ω
      G23-3 (LIN1) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - BATTERY AND BODY GROUND)


    1. A01DPV6E04
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Integration Control and Panel Assembly)

      Disconnect the G23 panel connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      G23-1 (+B) - G23-4 (GND) Always 11 to 14 V
      G23-5 (IG) - G23-4 (GND) Ignition switch off Below 1 V
      G23-5 (IG) - G23-4 (GND) Ignition switch ON 11 to 14 V
      G23-6 (ACC) - G23-4 (GND) Ignition switch ACC 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G23-4 (GND) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. REPLACE INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. Replace the integration control and panel assembly with a new or normally functioning one Click here.

    2. Operate the integration control and panel assembly to check that it functions properly.

      OK
      Integration control and panel assembly operates normally.

    NG

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    OK

    END (INTEGRATION CONTROL AND PANEL ASSEMBLY IS FAULTY)