REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side) INSTALLATION

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

    A01DQ3NE01
    Text in Illustration
    *a Protruding Part

    1. Install the inner belt and connect the 3 point type belt anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.

  2. INSTALL SEAT CUSHION COVER WITH PAD


    1. A01DQIT

      Attach the hook.

    2. A01DOAD

      Attach the hooks to install the seat cushion cover with pad.

    3. w/ Seat Heater System:


      1. A01DR50

        Pass the wire harness as shown in the illustration.

      2. A01DSJ3

        Connect the 2 rear seat heater connectors.

  3. INSTALL REAR SEATBACK LOCK STRIKER COVER LH


    1. Attach the 3 clips to install the rear seatback lock striker cover LH.

  4. INSTALL REAR SEAT CUSHION MOULDING LH

    A01DRMT

    1. Move the rear seat cushion moulding LH in the direction of the arrow to attach the guide.

    2. Attach the 3 claws and clip to install the rear seat cushion moulding LH.

  5. INSTALL CENTER SEAT HINGE COVER LH

    A01DSIS

    1. Attach the 2 guides and install the center seat hinge cover LH with the clip.

  6. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH


    1. Install the reclining adjuster release handle LH with the 3 screws.

  7. INSTALL REAR SEAT UPPER RECLINING COVER LH

    A01DP0Y

    1. Attach the 3 claws to install the rear seat upper reclining cover LH.

  8. INSTALL REAR SEAT ASSEMBLY LH


    1. Install the rear seat assembly LH Click here.