REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side) REMOVAL

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE REAR SEAT ASSEMBLY LH


    1. Remove the rear seat assembly LH Click here.

  2. REMOVE REAR SEAT UPPER RECLINING COVER LH

    A01DSVIE01
    Text in Illustration
    *1 Protective Tape

    1. Using a screwdriver, detach the 3 claws and remove the rear seat upper reclining cover LH.

      Tech Tips

      Tape the screwdriver tip before use.

  3. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

    A01DMH2

    1. Remove the 3 screws and reclining adjuster release handle LH.

  4. REMOVE CENTER SEAT HINGE COVER LH

    A01DLY4

    1. Using a clip remover, remove the clip.

    2. Detach the 2 guides and remove the center seat hinge cover LH.

  5. REMOVE REAR SEAT CUSHION MOULDING LH

    A01DR94

    1. Using a clip remover, detach the clip.

    2. Using a moulding remover, detach the 3 claws.

    3. Move the rear seat cushion moulding LH in the direction of the arrow to detach the guide and remove the rear seat cushion moulding LH.

  6. REMOVE REAR SEATBACK LOCK STRIKER COVER LH

    A01DTGV

    1. Using a clip remover, detach the 3 clips and remove the rear seatback lock striker cover LH.

  7. REMOVE SEAT CUSHION COVER WITH PAD


    1. A01DSJ3

      w/ Seat Heater System:


      1. Disconnect the 2 rear seat heater connectors.

      2. A01DR50

        Pull out the wire harness as shown in the illustration.

    2. A01DSOO

      Detach the hooks.

    3. A01DO80

      Detach the hook and remove the seat cushion cover with pad.

  8. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

    A01DR92

    1. Remove the bolt and inner belt and disconnect the 3 point type belt anchor.