Driver Side Seat Belt Warning Light does not Operate

DESCRIPTION

When the ignition switch is turned to ON, the center airbag sensor transmits front seat inner belt LH*1 (or RH*2) state signals to the combination meter through the CAN. If the driver side seat belt is not fastened, the combination meter blinks the front seat belt warning light. If the seat belt is fastened, the warning light goes off.

Tech Tips

The front seat belt warning light on the combination meter assembly is used for both the driver side seat and front passenger side seat.

*1: for LHD
*2: for RHD

WIRING DIAGRAM

INSPECTION PROCEDURE

Note

The seat belt warning system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure Click here.

PROCEDURE

CHECK FOR DTC (AIRBAG SYSTEM)

Clear the DTCs Click here.

Check for DTCs Click here.

Result
Result	Proceed to
DTC is not output	A
Airbag system DTC is output	B

B

GO TO AIRBAG SYSTEM Click here

A

PERFORM ACTIVE TEST USING INTELLIGENT TESTER (DRIVER SIDE SEAT BELT WARNING LIGHT)

Operate the intelligent tester according to the display and select Active Test Click here.

Combination Meter
Item	Test Part	Control Range	Diagnostic Note
Driver Side Seat Belt	Front seat belt warning light	ON/OFF	Confirm that the vehicle is stopped and the engine is idling.

OK
Driver side seat belt warning light condition can be switched by Active Test.

NG

REPLACE COMBINATION METER ASSEMBLY Click here

OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY
1. Temporarily replace the center airbag sensor with a new one Click here.
NEXT
CHECK DRIVER SIDE SEAT BELT WARNING LIGHT
1. Check the driver side seat belt warning light function Click here.
  
  OK
  
  Driver side seat belt warning light operates normally.
NG
REPLACE COMBINATION METER ASSEMBLY Click here

OK

END (CENTER AIRBAG SENSOR IS DEFECTIVE)

SEAT BELT WARNING SYSTEM Driver Side Seat Belt Warning Light does not Operate