REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side) REMOVAL

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE REAR SEAT HEADREST ASSEMBLY


    1. Remove the rear seat headrest assembly.

  2. REMOVE REAR SEAT TRACK INNER BRACKET COVER

    A01DRO2

    1. Using moulding remover A, detach the 2 claws and guide, and then remove the rear seat track inner bracket cover.

  3. REMOVE REAR SEAT TRACK OUTER BRACKET COVER

    A01DND0

    1. Using moulding remover A, detach the 2 claws.

    2. Move the rear seat track bracket cover in the direction of the arrow to detach the 2 guides and remove the rear seat track outer bracket cover.

  4. REMOVE SEAT TRACK INNER BRACKET COVER RH

    A01DMNJ

    1. Using a clip remover, detach the 8 clips and remove the seat track inner bracket cover RH.

  5. REMOVE SEAT TRACK COVER RH

    A01DSYG

    1. Using a clip remover, detach the 5 clips and claw, and then remove the seat track cover RH.

  6. REMOVE REAR SEAT ASSEMBLY RH


    1. w/ Seat Heater System:

      Disconnect the seat heater connector.

    2. A01DSIQ

      Disconnect the center inner seat belt from the seat.

    3. Remove the 5 bolts and nut.

    4. Remove the rear seat assembly RH.

      Note

      Be careful not to damage the vehicle body.

      Tech Tips

      Be sure to remove the seat with the seatback folded down.