Click here

REAR FLOOR AIRBAG SENSOR INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL REAR FLOOR SIDE AIRBAG SENSOR


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Install the rear floor airbag sensor with the bolt.

      9.0 N*m 92 kgf*cm 80 in.*lbf
      Note:

      • If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that the rear floor airbag sensor is not loose.

    5. Connect the connector.

  2. Click here

    INSTALL REAR FLOOR SIDE AIRBAG SENSOR COVER


    1. Attach the clip and claw to install the cover.

    2. Return the floor carpet to its original position.

  3. Click here

    INSTALL REAR DOOR SCUFF PLATE LH


    1. Attach the 3 clips, 6 claws and 2 guides to install the rear door scuff plate.

  4. Click here

    INSTALL REAR DOOR SCUFF PLATE RH

    Tip:

    Use the same procedure described for the LH side.

  5. Click here

    INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)


    1. Install the quarter scuff plate with the 2 bolts.

  6. Click here

    INSTALL QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)

    Tip:

    Use the same procedure described for the LH side.

  7. Click here

    INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

    Tip:

    Use the same procedure for all rear No. 1 floor step covers.


    1. Attach the 2 claws to install the rear No. 1 floor step cover.

  8. Click here

    INSTALL REAR NO. 1 SEAT ASSEMBLY


    1. for 60/40 Split Double-folding Seat Type LH Side:


      1. Install the rear No. 1 seat assembly (Click here).

    2. for 60/40 Split Double-folding Seat Type RH Side:


      1. Install the rear No. 1 seat assembly (Click here).

    3. for 60/40 Split Tumble Seat Type LH Side:


      1. Install the rear No. 1 seat assembly (Click here).

    4. for 60/40 Split Tumble Seat Type RH Side:


      1. Install the rear No. 1 seat assembly (Click here).

    5. for 60/40 Split Slide Walk-in Seat Type LH Side:


      1. Install the rear No. 1 seat assembly (Click here).

    6. for 60/40 Split Slide Walk-in Seat Type RH Side:


      1. Install the rear No. 1 seat assembly (Click here).

  9. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  10. Click here

    CHECK SRS WARNING LIGHT


    1. Check the SRS warning light (Click here).