SIDE AIRBAG SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH


    1. Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note


      • w/ Navigation System (for HDD):

        After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    3. Install the side airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that the side airbag sensor is not loose.

    5. Connect the connector.

  2. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH


    1. A01DTJY

      Install the front door inner glass weatherstrip.

  3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01DNFL

      Connect the front door lock remote control cable assembly and front door inside locking cable assembly.

    2. Connect 2 connectors.

    3. w/ Seat Position Memory System:


      1. Connect the connectors.

    4. A01DN8I

      Attach the front door trim board sub-assembly by attaching the 4 claws of the front door inner glass weatherstrip as shown in the illustration.

    5. A01DSFI

      Attach the 12 clips and front door trim board retainer to install the front door trim board sub-assembly.

    6. Install the 3 screws.

  4. INSTALL ASSIST GRIP COVER LH


    1. A01DNFX

      Attach the 8 claws to install the assist grip cover.

  5. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH


    1. A01DNQ2

      Attach the 3 claws to install the inside handle bezel.

  6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    1. Attach the 2 claws to install the front door lower frame bracket garnish.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.