DESCRIPTION
The front airbag sensor RH consists of the diagnostic circuit and frontal deceleration sensor, etc.
If the center airbag sensor receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.
DTC B1610/13 is stored when a malfunction is detected in the front airbag sensor RH circuit.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1610/13 | Either condition is met:
|
|
WIRING DIAGRAM
INSPECTION PROCEDURE
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected Click here.
PROCEDURE
CHECK FRONT AIRBAG SENSOR RH
| *1 | Front Airbag Sensor LH |
| *2 | Center Airbag Sensor |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the front airbag sensor LH with RH and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in memory Click here.
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs Click here.
| Result | Proceed to |
|---|---|
| DTC B1610 is output | A |
| DTC B1615 is output | B |
| DTC B1610 and B1615 are not output | C |
Tech Tips
Codes other than DTC B1610 and B1615 may be output at this time, but they are not related to this check.
| A |
|
REPLACE CENTER AIRBAG SENSOR ASSEMBLY Click here |
| B |
|
REPLACE FRONT AIRBAG SENSOR RH Click here |
| C |
|
USE SIMULATION METHOD TO CHECK Click here