METER / GAUGE SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use these procedures to troubleshoot the meter/gauge system.

  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT

  3. CHECK FOR DTC*


    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result
      Result Proceed to
      DTC is not output A
      CAN DTC is output (for LHD with Entry and Start System) B
      CAN DTC is output (for LHD without Entry and Start System) C
      CAN DTC is output (for RHD with Entry and Start System) D
      CAN DTC is output (for RHD without Entry and Start System) E

      B

      Go to CAN COMMUNICATION SYSTEM Click here

      C

      Go to CAN COMMUNICATION SYSTEM Click here

      D

      Go to CAN COMMUNICATION SYSTEM Click here

      E

      Go to CAN COMMUNICATION SYSTEM Click here

      A

  4. CHECK FOR DTC*


    1. Check for DTCs Click here

    2. Clear the DTCs Click here

    3. Recheck for DTCs Click here

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

      A

      Go to step 7
      B

  5. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

      B

      Go to step 7
      A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Terminals of ECU Click here

    2. Data List / Active Test Click here

    3. Operation Check Click here


      NEXT

  7. REPAIR OR REPLACE


    NEXT

  8. CONFIRMATION TEST


    NEXT
    END