RELAY ON-VEHICLE INSPECTION


  1. INSPECT LIGHT CUT RELAY

    A01DT3C

    1. Remove the light cut relay from the engine room relay box.

    2. A01DNUSE01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the light cut relay.

    3. Install the light cut relay to the engine room relay box.