IGNITION KEY CYLINDER LIGHT REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE INSTRUMENT SIDE PANEL LH

    A01DNBCE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel.

    2. Using a moulding remover, detach the 5 clips, claw and 3 guides and remove the instrument side panel.

  2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

    A01DM0OE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument cluster finish panel ornament.

    2. Using a moulding remover, detach the 3 clips and remove the instrument cluster finish panel ornament.

  3. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

    A01DREC

    1. Detach the 4 clips.

    2. Disconnect each connector and remove the instrument panel finish plate garnish.

  4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    A01DP35

    1. Detach the 4 clips.

    2. Disconnect each connector and remove the instrument panel finish panel.

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    A01DN01

    1. Detach the 4 claws, 2 clips and 2 guides and remove the instrument cluster finish panel.

  6. REMOVE LOWER STEERING COLUMN COVER


    1. A01DSYF

      Remove the 2 screws.

    2. Detach the 2 claws and remove the steering column lower cover.

  7. REMOVE UPPER STEERING COLUMN COVER


    1. A01DTNW

      Detach the 4 clips.

    2. Detach the claw and remove the steering column upper cover.

  8. REMOVE TRANSPONDER KEY AMPLIFIER


    1. A01DT0I

      Remove the screw and cover.

    2. A01DRDU

      Turn the key amplifier as shown in the illustration to detach the 2 claws and remove the key amplifier.

    3. Disconnect the connector.