PERSONAL LIGHT (for Front Door) REMOVAL

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    1. A01DSYT

      Detach the 2 clips and remove the front door lower frame bracket garnish LH.

  2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH


    1. A01DTXC

      Using a moulding remover, detach the 3 claws and remove the inside handle bezel as shown in the illustration.

  3. REMOVE FRONT DOOR ARMREST COVER LH


    1. A01DP43

      Using moulding remover A, detach the 8 claws and remove the assist grip cover.

  4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01DSFI

      Remove the 3 screws.

    2. Remove the 12 clips.

    3. A01DNCTE01
      Text in Illustration
      *1 Reference Boss

      Pull out the front door trim board sub-assembly in the direction indicated by the arrow in the illustration.

    4. Raise the front door trim board sub-assembly to detach the 4 claws and remove the front door trim board sub-assembly together with the front door inner glass weatherstrip LH.

    5. A01DS0Y

      Disconnect the 2 connectors.

    6. w/ Seat Position Memory System:


      1. A01DUBS

        Disconnect the connectors.

    7. A01DTZ7

      Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly.

  5. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH


    1. A01DOEY

      Using a screwdriver, detach the 4 claws and remove the front door inner glass weatherstrip from the front door trim board sub-assembly as shown in the illustration.

  6. REMOVE FRONT DOOR INSIDE HANDLE ILLUMINATION LIGHT ASSEMBLY LH


    1. A01DSDQE01
      Text in Illustration
      *1 Protective Tape

      Disconnect the connector.

    2. Using a screwdriver, detach the claw and remove the light.

      Tech Tips

      Tape the screwdriver tip before use.

  7. REMOVE NO. 2 INTERIOR ILLUMINATION LIGHT SUB-ASSEMBLY


    1. A01DSPS

      Disconnect the connector.

    2. Detach the clamp.

    3. Turn the light in the direction indicated by the arrow and remove it.