ROOM LIGHT (for Front) INSPECTION


  1. INSPECT MAP LIGHT ASSEMBLY


    1. A01DTG6E18
      Text in Illustration
      *a

      Component without harness connected

      (Map Light Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      21 (+B1) - 15 (GND1) Spot light switch off 10 kΩ or higher
      Spot light switch on Below 1 Ω
      21 (+B1) - 1 (CTY) Not door position 10 kΩ or higher
      Door position Below 1 Ω

      If the result is not as specified, replace the map light assembly.