THEFT DETERRENT SYSTEM Intrusion Sensor Cancel Switch Circuit

DESCRIPTION

• When the intrusion sensor OFF switch on the map light assembly is pressed, the sensor off signal is sent to the main body ECU which causes the theft warning radar sensor (intrusion sensor) to stop operating.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING INTELLIGENT TESTER (INTRUSION SENSOR OFF SWITCH)

   
   

   1. Using the intelligent tester, read the Data List Click here.

      Main Body

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      Intrusion Sens OFF SW	Intrusion sensor OFF switch / ON or OFF	ON: Intrusion sensor OFF switch pushed OFF: Intrusion sensor OFF switch not pushed	-

      OK
      ON (intrusion sensor OFF switch pushed) and OFF (intrusion sensor OFF switch not pushed) appear on screen according to switch condition.

   
   

   NG

   INSPECT MAP LIGHT ASSEMBLY (INTRUSION SENSOR OFF SWITCH) Click here

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

2. INSPECT MAP LIGHT ASSEMBLY (INTRUSION SENSOR OFF SWITCH)

   
   

   1. 

      Remove the map light Click here.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition 5 (GND3) - 26 (SOFF) Intrusion sensor OFF switch pushed Below 1 Ω 5 (GND3) - 26 (SOFF) Intrusion sensor OFF switch not pushed 10 kΩ or higher

   
   

   NG

   REPLACE MAP LIGHT ASSEMBLY (INTRUSION SENSOR OFF SWITCH) Click here

   OK

3. CHECK HARNESS AND CONNECTOR (MAP LIGHT - MAIN BODY ECU AND BODY GROUND)

   
   

   1. Disconnect the W7 light connector.

   2. Disconnect the G64 ECU connector.

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition W7-26 (SOFF) - G64-23 (SSW1) Always Below 1 Ω W7-26 (SOFF) or G64-23 (SSW1) - Body ground Always 10 kΩ or higher W7-5 (GND3) - Body ground Always Below 1 Ω

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR

   OK

   REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here