Click here

ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) ID Code Box Power Source Circuit

Click here
Click here Click here
DTC Code DTC Name
  ID Code Box Power Source Circuit
Click here

DESCRIPTION

This circuit provides power to operate the ID code box.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY AND BODY GROUND)


    1. A01DNA4E04

      Disconnect the G37 box connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      G37-1 (+B) - Body ground Always 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G37-8 (GND) - Body ground Always Below 1 Ω
      Table 1. Text in Illustration
      *a

      Front view of wire harness connector

      (to ID Code Box)

  2. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  3. Click here

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here