WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System), Diagnostic DTC:B1242

DTC Code DTC Name
B1242 Wireless Door Lock Tuner Circuit Malfunction

DESCRIPTION

The door control receiver receives signals from the transmitter and sends these signals to the main body ECU. This DTC is stored when the applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU.

DTC Code DTC Detection Condition Trouble Area
B1242 The applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU.

  • Harness or connector

  • Door control receiver

  • Main body ECU (multiplex network body ECU)

WIRING DIAGRAM

A01DS3BE02

INSPECTION PROCEDURE

Note


  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • When replacing the door control receiver, refer to the registration procedures Click here.

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs Click here.


    NEXT

  2. CHECK FOR DTC


    1. Check for DTCs Click here.

      OK
      DTC B1242 is not output.

    NG

    CHECK DOOR CONTROL RECEIVER (DOOR CONTROL RECEIVER - MAIN BODY ECU) Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here

  3. CHECK DOOR CONTROL RECEIVER (DOOR CONTROL RECEIVER - MAIN BODY ECU)


    1. Disconnect the R26 receiver connector.

    2. Disconnect the G64 ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      R26-2 (RDA) - G64-26 (RDA) Always Below 1 Ω
      R26-3 (PRG) - G64-25 (PRG)
      R26-2 (RDA) or G64-26 (RDA) - Body ground Always 10 kΩ or higher
      R26-3 (PRG) or G64-25 (PRG) - Body ground

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND)


    1. A01DO9IE05
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Door Control Receiver)

      Disconnect the R26 receiver connector.

    2. Measure the resistance and voltage according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      R26-1 (GND) - Body ground Always Below 1 Ω
      Standard Voltage
      Tester Connection Condition Specified Condition
      R26-5 (+B) - Body ground Always 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  5. REPLACE DOOR CONTROL RECEIVER


    1. Temporarily replace the door control receiver with a new one.


    2. Perform the registration procedures Click here.


    NEXT

  6. CLEAR DTC


    1. Clear the DTCs Click here.


    NEXT

  7. CHECK FOR DTC


    1. Check for DTCs Click here.

      OK
      DTC B1242 is not output.

    NG

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

    OK

    END (DOOR CONTROL RECEIVER IS DEFECTIVE)