NETWORK GATEWAY ECU INSTALLATION

Tech Tips


  • A bolt without a torque specification is shown in the standard bolt chart Click here.

  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL NETWORK GATEWAY ECU


    1. Attach the 2 claws to install the network gateway ECU to the ECU integration box RH.

  2. INSTALL ECU INTEGRATION BOX RH


    1. Install the ECU integration box RH with the 2 nuts and bolt.

    2. Attach the harness clamp.

    3. Connect the connectors.

      Note


      • Do not twist the connectors of ECU when connecting them.

      • Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.

  3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY


    1. Attach the 2 claws to install the No. 2 air duct sub-assembly.

    2. Install the screw.

  4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    A01DMHCE01
    Text in Illustration
    *1 Bolt
    *2 Screw

    1. Connect each connector.

    2. Attach the 5 clips and claw to install the glove compartment door.

    3. Install the 2 bolts <C> and 2 screws <A> or <B>.

  5. INSTALL INSTRUMENT PANEL ORNAMENT


    1. Attach the 5 clips to install the instrument panel ornament.

  6. INSTALL INSTRUMENT SIDE PANEL RH


    1. Connect the connector.

    2. Attach the 5 clips, claw and 3 guides to install the instrument side panel.

  7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover.

    2. Install the screw.

      A01DNTKE01
      Text in Illustration
      *A for LHD *B for RHD

  8. INSTALL COWL SIDE TRIM BOARD RH

    Tech Tips

    Use the same procedure described for the LH side.

    for 5 Door: Click here

    for 3 Door: Click here

  9. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

    for 5 Door: Click here

    for 3 Door: Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.