Click here

CAN COMMUNICATION SYSTEM (for RHD with Entry and Start System) 4WD Control ECU Communication Stop Mode

Click here
Click here Click here
DTC Code DTC Name
  4WD Control ECU Communication Stop Mode
Click here

DESCRIPTION

Detection Item Symptom Trouble Area
4WD Control ECU Communication Stop Mode

Either condition is met:


  • "Four Wheel Drive Control" is not displayed on the "Bus Check".

  • "4WD Control ECU Communication Stop Mode" in "DTC Combination Table" applies.

  • Power source circuit of four wheel drive control ECU

  • Four wheel drive control ECU CAN branch wire or connector

  • Four wheel drive control ECU
Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Tip:

Operating the engine switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

Click here

PROCEDURE


  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the airbag system.

      Note:

      • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


  2. Click here

    CHECK FOR OPEN IN CAN BUS WIRE (FOUR WHEEL DRIVE CONTROL ECU CAN BRANCH WIRE)


    1. A01DOT6E05

      Disconnect the G53 four wheel drive control ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      G53-19 (CANH) - G53-20 (CANL) Engine switch off 54 to 69 Ω
      Table 1. Text in Illustration
      *a

      Rear view of wire harness connector

      (to Four Wheel Drive Control ECU)

  3. Click here

    CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BATTERY AND BODY GROUND)


    1. A01DUNLE03

      Connect the cable to the negative (-) battery terminal.

      Note:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

    2. Disconnect the G54 four wheel drive control ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G54-4 (GND) - Body ground Always Below 1 Ω

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      G54-3 (IG) - Body ground Engine switch on (IG) 11 to 14 V
      Table 2. Text in Illustration
      *a

      Rear view of wire harness connector

      (to Four Wheel Drive Control ECU)

  4. Click here

    REPAIR OR REPLACE FOUR WHEEL DRIVE CONTROL ECU CAN BRANCH WIRE OR CONNECTOR (CANH, CANL)

  5. Click here

    REPLACE FOUR WHEEL DRIVE CONTROL ECUClick here

  6. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR