Click here

POWER MANAGEMENT CONTROL ECU REMOVAL

Click here
Click here Click here
Tip:

  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here
  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. Click here

    REMOVE DOOR SCUFF PLATE ASSEMBLY RH

    Tip:

    Use the same procedure described for the LH side.


    1. for 5 Door:

      Remove the door scuff plate assembly LH (Click here).

    2. for 3 Door:

      Remove the door scuff plate assembly LH (Click here).

  3. Click here

    REMOVE COWL SIDE TRIM BOARD RH

    Tip:

    Use the same procedure described for the LH side.


    1. for 5 Door:

      Remove the cowl side trim board LH (Click here).

    2. for 3 Door:

      Remove the cowl side trim board LH (Click here).

  4. Click here

    REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Remove the screw.

    2. A01DNTKE01

      Detach the 3 clips and 2 guides and remove the No. 2 instrument panel under cover.

      Table 1. Text in Illustration
      *A for LHD *B for RHD
  5. Click here

    REMOVE INSTRUMENT SIDE PANEL RH


    1. Put protective tape around the instrument side panel.

      Table 2. Text in Illustration
      *1 Protective Tape

    2. Using a moulding remover, detach the 5 clips, claw, and 3 guides.

    3. Disconnect the connector and remove the instrument side panel.

  6. Click here

    REMOVE INSTRUMENT PANEL ORNAMENT


    1. Put protective tape around the instrument panel ornament.

      Table 3. Text in Illustration
      *1 Protective Tape

    2. Using a moulding remover, detach the 5 clips and remove the instrument panel ornament.

  7. Click here

    REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    1. Remove the 2 bolts <C> and 2 screws <A> or <B>.

      Table 4. Text in Illustration
      *1 Bolt
      *2 Screw

    2. Detach the 5 clips and claw.

    3. Disconnect each connector and remove the glove compartment door.

  8. Click here

    REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY


    1. A01DRAK

      Remove the screw.

    2. Detach the 2 claws and remove the No. 2 air duct sub-assembly.

  9. Click here

    REMOVE ECU INTEGRATION BOX RH


    1. Disconnect all the connectors.

    2. Detach the clamp.

    3. Remove the 2 nuts, bolt and ECU integration box RH.

  10. Click here

    REMOVE POWER MANAGEMENT CONTROL ECU


    1. Detach the 2 claws and remove the power management control ECU.