REAR DOOR SPEAKER INSPECTION


  1. INSPECT REAR SPEAKER SET


    1. for JBL Made:


      1. A01DT51E39
        Text in Illustration
        *a

        Component without harness connected

        (Rear Speaker Set)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 Always 1.8 to 2.6 Ω

        If the result is not as specified, replace the rear speaker set.

    2. except JBL Made:


      1. A01DT51E39
        Text in Illustration
        *a

        Component without harness connected

        (Rear Speaker Set)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 Always 4 Ω

        If the result is not as specified, replace the rear speaker set.

  2. INSPECT REAR NO. 2 SPEAKER ASSEMBLY


    1. for JBL Made:

      When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.

      OK
      Malfunction disappears.

      Tech Tips


      • Connect the connectors to the rear No. 2 speakers.

      • When there is a possibility that either the right or left rear No. 2 speaker assembly is defective, inspect by interchanging the right one with the left one.

      • Perform the inspection above on both the LH and RH sides.