STEREO COMPONENT AMPLIFIER REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT SEAT ASSEMBLY RH


    1. for Manual Seat Type:

      Click here

    2. for Power Seat Type:

      Click here

    3. for Walk in Seat Type:

      Click here

    4. for Bench Seat Type:

      Click here

  4. REMOVE AMPLIFIER COVER

    A01DPN2E01
    Text in Illustration
    *A for Pioneer Made *B for JBL Made
    *C w/ Seat Heater System *D w/o Seat Heater System

    1. Fold back the floor carpet.

    2. w/ Seat Heater System:


      1. Remove the 3 clips and amplifier cover.

    3. w/o Seat Heater System:


      1. Remove the 3 screws and clip.

      2. Detach the clamp and remove amplifier cover.

  5. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY

    A01DOIJE01
    Text in Illustration
    *A for Pioneer Made *B for JBL Made
    *C w/ Seat Heater System *D w/o Seat Heater System

    1. Disconnect each connector.

    2. Remove the bolt and 2 screws.

    3. Detach the guide and remove the stereo component amplifier assembly.

  6. REMOVE NO. 2 AMPLIFIER COVER

    A01DSSKE01
    Text in Illustration
    *A w/ Seat Heater System *B for JBL Made, w/o Seat Heater System

    1. w/ Seat Heater System:


      1. Detach the clamp.

      2. Remove the screw, bolt and No. 2 amplifier cover.

    2. for JBL Made, w/o Seat Heater System:


      1. Detach the 3 clips and remove the No. 2 amplifier cover.

  7. REMOVE NO. 1 AMPLIFIER BRACKET


    1. Remove the 2 screws and No. 1 amplifier bracket.

      A01DOO2E01
      Text in Illustration
      *A for Pioneer Made *B for JBL Made
      *C w/ Seat Heater System *D w/o Seat Heater System

  8. REMOVE NO. 2 AMPLIFIER BRACKET


    1. Remove the 2 screws and No. 2 amplifier bracket.

      A01DNQHE01
      Text in Illustration
      *A for Pioneer Made *B for JBL Made
      *C w/ Seat Heater System *D w/o Seat Heater System