AUDIO AND VISUAL SYSTEM (for Radio and Display Type) Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

A01DMSJE10

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the H69 radio and display receiver assembly connector.

    2. Disconnect the H68 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H69-2 (UDO-) - H68-2 (UDO-) Always Below 1 Ω
      H69-3 (UDO+) - H68-3 (UDO+) Always Below 1 Ω
      H69-2 (UDO-) - Body ground Always 10 kΩ or higher
      H69-3 (UDO+) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here