Click here

DRIVING SUPPORT SWITCH CONTROL ECU INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL DRIVING SUPPORT SWITCH CONTROL ECU


    1. Install the driving support switch control ECU with the bolt.

      13 N*m 127 kgf*cm 9 ft.*lbf

    2. Connect the connector.

  2. Click here

    INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    1. Connect each connector.

    2. Attach the 5 clips and claw to install the glove compartment door.

    3. Install the 2 bolts <C> and 2 screws <A> or <B>.

      Table 1. Text in Illustration
      *1 Bolt
      *2 Screw
  3. Click here

    INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover.

    2. A01DNTKE01

      Install the screw.

      Table 2. Text in Illustration
      *A for LHD *B for RHD
  4. Click here

    INSTALL INSTRUMENT PANEL ORNAMENT


    1. Attach the 5 clips to install the instrument panel ornament.

  5. Click here

    INSTALL INSTRUMENT SIDE PANEL RH


    1. Connect the connector.

    2. Attach the 5 clips, claw and 3 guides to install the instrument side panel.

  6. Click here

    INSTALL COWL SIDE TRIM BOARD RH


    1. Attach the clip and claw to install the cowl side trim board RH.

    2. Install the clip.

  7. Click here

    INSTALL DOOR SCUFF PLATE ASSEMBLY RH


    1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate assembly RH.

  8. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  9. Click here

    CHECK SRS WARNING LIGHT

    (Click here)