STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column) REASSEMBLY


  1. INSTALL KEY INTERLOCK SOLENOID WIRE (w/o Entry and Start System)


    1. Install the key interlock solenoid wire on to the install the ignition switch.

  2. INSTALL IGNITION SWITCH ASSEMBLY (w/o Entry and Start System)


    1. A01DNWK

      Install the ignition switch onto the steering column upper bracket with the 2 screws.

  3. INSTALL KEY INTERLOCK SOLENOID (w/o Entry and Start System for Automatic trans mission)


    1. A01DP4X

      Install the key interlock solenoid onto the steering column upper bracket with the 2 screws.

    2. Connect the connector.

  4. INSTALL UNLOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)


    1. A01DP6B

      Attach the 2 claws to install the unlock warning switch onto the steering column upper bracket.

      Tech Tips

      Slide the unlock warning switch in the direction shown by the arrow in the illustration to install it.

  5. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)


    1. Turn the ignition switch to ON (ACC).

    2. A01DOI4

      Install the ignition switch lock cylinder into the steering column upper bracket.

    3. Make sure that the ignition switch lock cylinder is securely fixed onto the ignition switch lock cylinder.

  6. INSPECT STEERING LOCK OPERATION (w/o Entry and Start System)


    1. A01DMU2

      Remove the key and check that the steering lock function is activated.

    2. A01DR8Q

      Insert the key, turn the ignition switch ON (ACC) and check that the steering lock function is deactivated.

  7. INSTALL STEERING LOCK ACTUATOR ASSEMBLY


    1. Temporarily install the steering lock actuator assembly with a new tapered-head bolt.

    2. A01DPG0E01
      Text in Illustration
      *A w/o Entry and Start System
      *B w/ Entry and Start System

      Tighten the tapered-head bolt until the bolt head breaks off.