STEERING ANGLE SENSOR INSTALLATION


  1. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

    Click here

    Note


    • Do not replace the spiral cable with the battery connected and the ignition switch ON.

    • Do not rotate the spiral cable with the battery connected and the ignition switch ON.

    • Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

    • Do not remove the steering angle sensor from the spiral cable.

  2. INSTALL STEERING COLUMN COVER


    1. for Manual Tilt and Manual Telescopic Steering Column:

      Click here

    2. for Power Tilt and Power Telescopic Steering Column:

      Click here

  3. ADJUST SPIRAL CABLE


    1. A01DM1D

      Rotate the spiral cable sub-assembly with steering sensor counterclockwise slowly by hand until it feels firm.

      CAUTION:

      Do not turn the spiral cable sub-assembly with steering sensor by the airbag wire harness.

    2. A01DO2WE01
      Text in Illustration
      *A w/o Steering Heater
      *B w/ Steering Heater
      *1 Alignment Mark
      *2 Colored Part
      *3 Flat Cable

      Rotate the spiral cable sub-assembly with steering sensor clockwise approximately 2.5 turns to align the marks so that the colored part or the flat cable shown in the illustration is visible.

      CAUTION:

      Do not turn the spiral cable sub-assembly with steering sensor by the airbag wire harness.

      Tech Tips

      The spiral cable sub-assembly with steering sensor can be rotated approximately 2.5 turns to both the left and right from the center position.

  4. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. CHECK SRS WARNING LIGHT

    Click here